XEIGU X6100 FIRMWARE 1.1.4

Xeigu nous délivre la dernière version de son firmware pour le X6100.
La version 1.1.4 annonce ces modifications dans le firmware:
App: V1.1.4 Feb 16 2022,17:15:50
- Add FFT peak hold switch, GEN > DISPLAY SETTING > FFT PK HOLD
- Fix bug « Gate Way » can’t save in « WLAN » setting page
- Change rx volume from 0-50 to 0-55(5dB more than prev version)
- Change CW decoder’s threshold to a higher level(better robustness but needs higher SNR)
- Calibrate the RX S-Meter giving more accuracy
- Add ALC level indicator(at the top-right of the bandscope area, below the tx power strings)
- Optimize the Fw flashing logic(base board will boot-up itself after flashed the Fw)
Base: V1.1.4 Feb 15 2022,13:19:59
- Fix bug built-in MIC feedback to speaker sometimes
- Fix bug base board some times not booting at power on
- Optimize ALC algorithm
- Optimize SWR algorithm, less jumping around
- Optimize switching power synchronization algorithm, less birdies
Tips:
☆ ALC tricks
a) ALC level equ to 0: over driving, decrease input signal level
b) ALC level equ to 100: under driving, increase input signal level
c) When doing Digi,the audio baseband signals are almost constant amplitude,
adjust the soundcard volume to make ALC level between 20-80 to get good linearity
Le nouveau firmware est téléchargeable sur notre espace de stockage en ligne.
Pour rappel voici la procédure de mise à jour du Firmware: